CUTTING PARAMETERS EFFECT ON HARDNESS OF AISI 1020 MILD STEEL IN LATHE MACHINING PROCESS
Keywords:
RSM, Manufacturing, Lathe MachineAbstract
Boosting the productivity in lathe machining by increasing the parameters could affected the surface integrity of the finish product. The main objective of this work is to investigate cutting parameters of lathe machining process towards the hardness of AISI 1020 Mild Steel. Lathe machine parameters chosen is feed rate, depth of cut and cutting speed and the response analyse is the surface hardness. The study used a design of experiment (DOE) approach through By using box-Bhenken Response Surface Methodology (RSM) to vary the cutting parameters setting. The output response (surface hardness) was measured for each run, with three number of factors design and the data was analysed using one way Analysis of Variance (ANOVA. From the RSM analysis, found that cutting speed is the most influential factor affecting hardness value of AISI1020 mild steel. Meanwhile, feed rate followed second as the most influential factor affecting the hardness and lastly is depth of cut. Result from One way ANOVA also shows the similar result from RSM, is shows that cutting speed is the most influential factor towards hardness with value of R-Sq% obtained is 37.40% then followed by feed rate with 19.97% and lastly is depth of cut with 0.83%. From the experiment, it can conclude that if characteristic hardness of the finish product is important, cutting speed value should be prioritized first when setting the lathe machining parameters.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Seminar Pembelajaran Sepanjang Hayat (SPSH) 2025

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.